По чему произошла ошибка при регистрации

Почему иконка стала оранжевым

Following the registration of Boostspeed 11, when I try to run my Kaspersky Total Security scan it stops at 1% and will not scan any further. Is there a setting in the Boostspeed 11 that is causing this and what do I need to do to rectify this

Hello,

Boostspeed runs every Sunday morning as part of scheduled maintenance I set-up. After it runs, I am prompted to re-enter my product key for Fences. I do this and Fences works fine. This is a nuicance though as I should not need to do this - the Fences registration is valid. Given the timing is consistent, I am assuming Boostpeed is causing this issue.

Several weeks ago, I did exempt my Anti-Virus software from scanning the Fences folder which contains the registration certificate. However, the prompts continue.

If Boostspeed is indeed causing this issue, is there a way to have it avoid removing/maninpulating the registration of this software so I don't have to re-enter the product code weekly?

Attached is the dialogue box that appears requesting to re-enter the product key.

Thanks,
Rich Sullivan

У меня сломалась корзина на диске L. Как это устранить?

j'ai un pc hp compaq 6730s sous N°=CNU9020NKN
mon mot de passe par defaut (e9lo1719s9) n'a pas d'effet
j'ai change la pile bios rien
j'ai utilise hiren's bootcd rien
Aider mois s.v.p et merci d'avance................

Hi! Everytime that I run Auslogics, that scans my computer for errors, cleans websites, etc.), my printer stops connecting properly with my computer. It appears that it affects the drivers. I have to clean out the printer, reinstall, etc., that takes a great deal of time. Your program speeds up my computer, which is great. But this repeated problem with my printer is a serious issue. Is there anything that I can do to stop this problem. You might need more information to solve the issue. I am happy to provide it.

После сканирования удаляет все пароли как отключить

I cannot seem to resolve the freezing problem. sometimes it freezes after a very short time after start-up and occassionally it works for quite sometime before it freezes again.

Do you have any suggestios what I can do to stop this or how I can find what may be causing this.

I am not a technical person so any answer have to be spoon-fed.

Thanks

When I click on the box to do away with empty folders, nothing happens. It used to work but I stopped it in the middle of its job.