My printer is connected via USB (previously by network). Each time I run a scan and fix with Auslogics Boostspeed 12, I have reinstall the printer drivers from the ground up. Why is this? Is there a feature that I should not run to avoid this? Please advise.

Greetings,
After installing your product software, my HP Office Jet Pro 9010 series PCL-3 stopped printing.
Although the printer is wireless connected. The PC sees the printer. HP diagnostics says that the printer is working and connected.
So everything as far as I can observe is connected and working.

When I click the print button in WORD, the printer goes through its process, makes all the clicking sounds and it just stops without printing. I looked at the printer queue and the document loads, then it disappears from the queue and nothing happens.
The printer quiets down and stops dead. Although the printer is connected and on.

By the way, I have a 2 laptops also connected to the printer by WIFI. These laptops do not have your software installed on them. When I print from them, the printer works. So, I know that the printer is working correctly. Besides, it's new!

Thank you... hope you can help...
Al Sosa

Bonjour,
Pourquoi après chaque mise à jour de votre produit, mon imrpimante ne fonctionne plus, je suis obligé de la désinstaller puis refaire une installation. ce qui du temps et de l'argent perdu. Si cela continu, je me verrai dans l'obligation de ma séparre de vos services.
Salutation.

Hello!
I recently used Auslogics to clean my computer. I believe I went to "optimize" to perform a deeper clean up. The question came up at the end to clean which I clicked on. My printer is now showing default, I cannot get it to connect to my internet either by the "wizard" or manually. HELP!!!

how to reselove unexpected configuration 0x80004005 when I try to pring

Доброго времение суток! После сканирования компьютера Boos и обновления драйверов с помощью Вашей программы, система стала выдаать ошибку 45 при раюоте принтера HP 1020. Как это исправить?