Drive C: - Reports Disk has errors
Despite the statement that the report provides details on disk error check AND REPAIR RESULTS, the report simply states that my C:Drive has errors.
There is no indication as to what the errors are or that they have been repaired; on the contrary the errors have not been identified nor have they apparently been repaired.
How do I find out what the errors are and how do I repair them?
Regards, Harry McBride
System Information Report
ID: 05
Name: Reallocated sector count
Value: 134
Worst: 134
Threshold: 140
Raw Data: 522
Status: Prefail
What does this mean and how do I fix it?
Lizenz
Delete wrong user
Want to delete wrong choise
Unable to activate Auslogics Bootspeed 12 PRO Version
Windows refusing access as administrator
ユーザー制御
デスクトップのショートカットから、ブーストスピード開きません。タスクバーからなら開くのに。ユーザー制御ウィンドが出てダメです。ドライバーアップデーターのショートカットも同じです。また、時々ですが、ブーストスピードが開いた時に、すべての画面が白紙画面になります。
アカウントとかセキュリティーの調整をしてみたのですが変わりません。インストールしなおしても変わりません。セキュリティソフトが干渉でもしているのでしょうか?何か良い方法はないでしょうか、お願いします。
Could not activated my license
Program not registered
Thank you
Activating Software Problem
I have now come to the end of my tether with this piece of software. I have been sent a Registration Code because the software I purchased on the 14 Dec 2021 keeps on asking me to Activate Pro Version. I removed the programme from my computer and started afresh. The programme dowloaded and the after putting in my Licence Key it advised me that the programme was registered. However, there is white writing on a green backgroumd in the bottom right hand corner stating: Activate Pro Version (when pressed advises what you get with the Pro version - which I have already purchased!) I have added this as an attachement on an MS Word doc.
Carl Bruce
BOOT SPEED PRO
I HAVE RENEWED MY BOOT SPEED SUBSCRIPTION BUT I CAN'T PERFORM CERTAIN FUNCTIONS I AM ASKED TO TAKE PRO VERSION WHILE I HAVE ALREADY PAID THE BASIC VERSION HOW TO UPGRADE TO THE PRO VERSION WITHOUTPAYING THE 50 EUROS MORE ?
LICENCE N°:
THANK YOU
Aktivation not Possibel
I did try to activate the pro version.
Reslult: The product has been activated
But in realatiy is the green botten still here and its not working as should when activated.
Regards
Kurt
Auslogics 12 is blocked by Windows 10
My Auslogics 12 is blocked by Windows 10. What can I do to fix this problem? And I cannot to set my Auslogics license key. I have just a basic version of programm now.
Программа была заблокирована администратором
About Auslogics BoostSpeed 12
Auslogics BoostSpeed 12 The software is blocked by the administrator. ソフトが管理者によってブロックされています。
Please unblock ブロック解除をお願いします
Hirosuke Kajiyama
Auslogics BoostSpeed 12 The software is blocked by the administrator. ソフトが管理者によってブロックされています。
Please unblock ブロック解除をお願いします
License key ライセンスキー:
Auslogics BoostSpeed 12
Pro version ?
Plus the last time i used driver updater it updated my pc then restarted it and it would not boot up no matter what i tried, I then had to reinstall windows with a backup. not used driver updater since.
Thank You.
Admin. Blocked
Thank You
James Elder
Не активируется программа при наличии лицензионного ключа
Blank Windows Security Window
Suggestions wecome. My understanding is that Defender is operating but not lettting me see that it is operating. I wish I could be sure of that.
Windows 10 Restart Stalls
If it wasn't for windows updates I could live with not using the restart option. However, windows update requires the restart so I expect it to fail each time there is an update. Recently did scan and did the suggested tweaks in the Maintain section of BoostSpeed 11. Any thoughts or suggestions?
I am not getting full gigabit speed on only my computer.
Hello all, happy holidays!
Unfortunately things aren't so smooth for me right now, I have just installed gigabit internet in my home, but I'm having the problem that my computer is not getting the full speed. I know the modem is putting out 940 average, because I have an eero Pro connected to it and that reads 940, and my dad's laptop on wired connection also reads 900 average, it is only my computer that is not getting the full speed on the same wired connection. It gets on average 250 Mbps, sometimes stooping lower and upload is always the same speed at 40 Mbps up.
I am using a Cat6 cable not 5 ft from the standard xfinity modem, I have reset my network settings and flushed my DNS. I have used DNS Benchmark to make a custom list of the fastest DNS Servers for me. I have downloaded and check my ethernet adapter with Intel PROSET and everything checks out. My adapter has a max speed of 1 Gbps (Intel(R) Ethernet Connection (2) I218-V). I have run virus and malware scans and came out clean. I have tried disabling windows firewall and running only ipv4 or 6. Among other things I have tried A LOT of troubleshooting and my knowledge has limited me at this point
Режим сна
Can't install update
On two occasions, I attempted to install the updated version of Boost Speed 11. Each time I got the Blue Screen of Death. That's unacceptable for the $50 I paid for the full registered version. Please advise a fix.
Пропали значки из трея
speaker icon
after todays update the sound icon when clicked upon appears ok but as soon as the mouse is moved to adjust the sound the icon disappears
What can I do to bring it back to normal?
By the way: the subcategory is too limited to direct the problem to the right technician in the correct dept.
Failed Windows Updates
(2019-10 Cumulative Update for Windows 10 Version 1903 for x64-based Systems (KB4517389) - Error 0x80070002)
My system is a Lenovo Think Centre w/I5 Processor.(M91)
How do I stop starting up when I start the computer
When I start up my computer, PCTuneUp starts up. How do I prevent this from happening.
Problem with VPN
Super slow opening of files and folders
For the last week I am having issues opening any file or folder. It seems like it takes a minute or 2 for them to open. It is driving me nuts.
I have tried most of the items in https://windowsreport.com/file-explorer-slow-windows-10/ with no effect.
Anything you may provide would be appreciated!
Thank you
Robert
Unable to download standard apps like calculator etc
No se le da acuse de recibo cuando envia alguna informacion. (Es una recomendacion positiva Suprema.
BoostSpeed 11 Pro being used with license: Cuando el cliente envia alguna informacion a Auslogics, si Auslogics no le da un acuse de recibo, aunque pudiera ser breve, el cliente tiene dudas de si Auslogics lo recibio.
Printer not connecting
I recently used Auslogics to clean my computer. I believe I went to "optimize" to perform a deeper clean up. The question came up at the end to clean which I clicked on. My printer is now showing default, I cannot get it to connect to my internet either by the "wizard" or manually. HELP!!!
Windows Settings
I can't access my Windows Settings. When I try to access it the page shows and then goes away. Can your software fix this issue?
Cortana
Regards
John
No sound after connectin phone with bluetooth
Regarding RAM Optimization
Hi, This's Mainak. Today I Activated Your License. Can You Help Me Out How To Enable "RAM Optimization".
Would Like To Have Reply On This.
Thanks
Mainak