Buenos dias, tengo un problema con la aplicacion Auslogics Driver Update, ya solicite anteriormente me solucionen este problema, inclusive me solicitaron que reinstale el aplicativo, pero no se soluiciona este proble, por favor tengo que actualizar algunos drivers, pero se queda la PC congelada cuando va hacr la actualizacion de dichos driver, para constancia les envio fotos del problema.
Whenever my VPN connects to the internet, the Auslogics Bootspeed notifies, an attempt to change the DNS was diplayed. Well if I connect via VPN it will change the DNS. My question is does your softwere blocks the attempted change of DNS or it's only a notification. If it blocks then how do I dissable it as I want my VPN more than your software.
Many thanks in advance for your response.
This is the second time this has happened and it has something to do with this softwarre Auslogics 11 after a deep scan took place. But now I cant restore the driver because it seems to be blocked,
The diagnostic's say "Windows can not bind the IP protocol stack to the network."
This is with my wireless adapter and not with my LAN, But I need my wireless adapter asap. Yes I have tried reinstalling the driver and it says the same thing,
If I have to restart, it takes 20 minutes or more to load completely. I have basically nothing in startup and can't figure out what is making this take so long. It's the same whether a restart or new start. The hard drive is only a little over half full with lots of pictures. Logically it has to be in either ASUS or windows (10). It's very frustrating and because it takes so long to load, I leave it running. For quite a few years I paid for a service that cleaned the system once a month and helped with any problem. I am no longer using it as it was expensive and even though I stressed the startup time issue, they never improved it.
You can see a lot about the machine, but it doesn't say it's an ASUS 15" laptop, purchased in September of 2014, model R510LAVS51 with core i5
I didn't know if you needed this, but I'd rather give you unnecessary information than have you come back to me.
thanks so much
Hello - I have your Auslogics Anti-Maleware program and recently added Norton Security. Norton security runs scans in the backgound and for some reason goes after the anti-malware prgram, esentially erasing it. However it leaves my Auslogics BoosSpeed & Auslogics Driver Update prgrams alone, so they continue to run fine. Now every day I have to re-load the anti-malwar program.
I went into Norton checking the Virus & Firewall settings which are set to "allow" your anti-malway program , but it still continues to erase the entire anti-malware application. Do you have any ideas on how to fix this in Norton..?
i downloaded the booster 11 for windows 10.
the booster 11 shows as 32 bit. ideally i need a booster 11 64 bit.
i am using windows 10 on a 64bit system.
do i have to reinstall for booster 11 for 64 bit. if so, can you send me the link as it just auto-downloads the 32bit.
another questions is i have anti-malaware and everytime i shut down the computer and restart the next day, i have to reinstall all over again.
is it because of my anti-virus norton that i use? can you assist me on that as well.
After receiving the most recent Win 10 update and installing it, both shift keys have stopped working and I can't get upper case symbols.
I'm writing this on my old desktop, winxp. the Laptop in question is running Win10 having originally run on
Win7, then Win8 and now Win 10.
iVe tried rollback, updating drivers and restarting, deleting and reinstalling, checking Sticky Keys etc, also checking language layout.
I'm at my wit's end, can you help me please?